Home | Rigs | Predator Rigs | Twisting A Pike Trace

Twisting A Pike Trace

Font size: Decrease font Enlarge font
Graham Marsden 11/11/2002 10:17:01
image Twisting A Pike Trace

Step by step guide to making a 'snap-tackle' pike trace by twisting rather than crimping.


Everything you need to twist a trace

MAKING A PIKE TRACE BY TWISTING

Cut off a length of trace wire, about 2ft.


thread the wire through the eye of the hook and then back through so that you have, in effect, pushed a loop through the eye

Push the hook through the loop and slowly tighten as shown

Pull wire loop over eye and pull tight so that wire tightens on itself as shown

Clamp forceps to wire very tightly to hang at this angle, then swing forceps around wire......

...... so that it twists over main wire without overlapping (You'll need to do a few before you get the knack!)

Trim off tight to main wire

Slide top treble onto wire to distance required and then fold as shown

Take three turns round shank of hook and then......

......thread through eye

Twist on swivel as described for first treble

One complete, twisted wire trace

About the Rigs Page

The Rigs Page is a library of features to illustrate all those rigs that will be useful to both beginners and experienced anglers.

The rigs can be extremely simple and well known, or very complicated and little known, it doesn't matter providing they make some kind of sense and have a really practical application.

It could be a standard running leger rig that a beginner will appreciate seeing in pictures, or a very complicated anti-eject carp rig that the experienced carp angler would like to see.

If you wish to contribute a rig to this section please remember that the emphasis is on illustration rather than words. Good line drawings are fine in the absence of photographs. Please send to graham@fishingmagic.com



  • email Email to a friend
  • print Print version
  • Plain text Plain text
Tags
No tags for this article