robtherake
Well-known member
Preferably just a tip section (broken in an act of unparallelled clumsiness
), but I'll be happy to buy a full rod
), but I'll be happy to buy a full rod 
Wanted: Pro Performance Graphite pro margin match rod, 10ft.
- Thread starter robtherake
- Start date
robtherake
Well-known member
Bump. Still can't find one.
robtherake
Well-known member
Bump. Fixed the tip by using a section of carbon quivertip as a spigot and then whipping over the break. The action's only a little stiffer and the repair doesn't look too obvious.
Still looking for another, though
Still looking for another, though
robtherake
Well-known member
Bump. Still looking
robtherake
Well-known member
Thanks, Titus. It was all I had that was the right size, so it had to do. Fortunately, the edges of the break married up perfectly, so it was a fairly simple job in the end.
I'd already "replaced" it with a Browning Commercial King F1 ten footer, but it's not as well balanced as the Pro Performance rod. Part of that may be down to the ultra-short handle on the Browning, which means that the effective length of the rod in front of the handle is increased by 6".
I'd already "replaced" it with a Browning Commercial King F1 ten footer, but it's not as well balanced as the Pro Performance rod. Part of that may be down to the ultra-short handle on the Browning, which means that the effective length of the rod in front of the handle is increased by 6".