Pole pots

I have been given a set of frenzee pole pots to use with a spare top kit.
I have made it the same length as all my topkits but the thread connector is a little to big to go on the end of my topkit. Any ideas how to solve this would be much appreciated.
Steve

steviebearuk said:

I have been given a set of frenzee pole pots to use with a spare top kit.
I have made it the same length as all my topkits but the thread connector is a little to big to go on the end of my topkit. Any ideas how to solve this would be much appreciated.
Steve

Click to expand...

Yeah ,you,ll have to cut it back a bit more until it fits!,if its not too much,wont make much difference,just make allowances when cupping in bait...only other thing you can do ,is to try and sleeve the top section,to build up the diameter a bit,then araldite it all together,without seeing it ,its hard to give any better advice..Gazza

Electrical tape??

Wrap some around the end to bult it out a bit?? I'm 'riffing' but might work?