Polemaster Pots

D

Danny Lancaster

Guest
I've just bought a set of the polemaster pole cups and a universal kit. I've cut and filed everthing back as necessary but am a bit wary as to which glue/adhesive to use to attach the screw-in fitting to the tip of the section.

Loads of glues are a bit vague in their description, ie. "bonds most plastics" but I am a bit wary of this.

Any advise?

Dan
 
E

ED (The ORIGINAL and REAL one)

Guest
that hot melt glue stuff ---then if you need to get it off you just warm it .......
 
W

William Spencer

Guest
best glue to use would be a two part epoxy adhesive,or two part araldite
 
E

ED (The ORIGINAL and REAL one)

Guest
with Araldite or epoxy resin you wouldnt be able to remove it -should you need to
 
D

Danny Lancaster

Guest
Hmmmm...thanks chaps. I think I'll get the araldite.

Like the idea of the hot melt stuff though.

Thanks again,
 
E

ED (The ORIGINAL and REAL one)

Guest
the hot melt stuff is good for tip rings too
 
W

William Spencer

Guest
scouse ed uni cupping top kits are only a tenner in our neck o the woods,so,if you get to a point where something needs replacing ten quid won't break the bank.
 
E

ED (The ORIGINAL and REAL one)

Guest
You must be a rich southerner ......
 
J

jason fisher

Guest
he cant be in the south eddie they'd cost 30 quid then.
 
You must log in or register to reply here.
Top