jollyboy
Well-known member
I recently sold a rod and sent to Germany on arrival the end of the top section where the quiver tip fits in got broke (Did well out of the insurance) Just to see if it would work I tried one of the tips in the section and it still fits as snug as a bug and as only about 2-3 inch broke off and with the tip in it looks right.
So my question is....Is there any rod builders here that can dress (whip) the end of the rod and finish it in the same way as the rest of the rings? and what am I looking at for getting the job done?
It is one of the Dutch Master rods I was selling on the forum (Later sold on Ebay)
Kev
So my question is....Is there any rod builders here that can dress (whip) the end of the rod and finish it in the same way as the rest of the rings? and what am I looking at for getting the job done?
It is one of the Dutch Master rods I was selling on the forum (Later sold on Ebay)
Kev
Last edited: